Increase the inputs, saving energy and reducing consumption

At present, the quality of the aluminum production requirements

With the change of market demand and become more and more high

Especially for solar energy of the smooth surface oxidation electrophoresis production abroad

At the state of the best

How to improve the means of production?

How to improve the smooth surface oxidation electrophoresis material one-off yield?

How to improve the surface quality?

Every oxidation production workshop is faced with problems

In the process of oxidation of vertical line production

Oxidation electrophoresis often have "touch paint", "paint mark" bad

In the daily rework material proportion is higher

In order to solve the above problems

Our r&d staff

With a profile production technology departments of the company

To design a set of anti-collision fixture

Through application in practice gradually improve in a short period of time through the test can already meet the practical need of the production auxiliary well the mass assembly line production

And to further improve the production operation and process of a complete set of standard processes

Oxidation of collision of hanging line using a jig

As the name implies its function is to prevent collisions in the process of production

Initially set hanging production mainly for electrophoresis is expected to appear "touch paint" and the development of fixture

Goal is to reduce the chafed, bruised, touch paint to achieve a yield increase.

Customers to use instance

The basic operating methods are as follows:

Stores: so long as area girder holding process finished, hit the shelves on the lower end of the bar with a small clip all clips can be (profile can be shown in case of individual interval larger clamping);

Shelves way: normally catch on both ends of the jig, hard and take advantage of an opportunity in the future can clamp of a complete set of a, is very convenient.

By plastic rubber bucket collection: collection, to the stores from the shelves.

Thus, a complete set of production operation is very convenient and quick,

With the very simple? In fact it is not easy!

Use creative attitude to face every detail

Electrophoretic material in the process of vertical oxidation production line, adopt efficient collision avoidance for production, particularly evident in the number of stores advantage, to a certain profile manufacturer's actual production conditions, for example: they had a row of 108 cigarettes, can now in 188, originally a trough in 324, now can reach 564, more than 240, can be calculated, a groove material than the original shelves number increased by 68%, with vertical automatic continuous oxide scale production mode, the 68% improvement is a great achievement.

In a yield analysis, the original traditional vertical hanging production, often appear bad touch paint, this kind of bad product can rework processing, but rework difficulty bigger, so as to improve the consumption, production cost directly affect the yield, according to the cooperation with the manufacturer's statistics: touch paint defective rate up to 4%, including rework scrap about 0.15%; By high anticollision raw postpartum, has been basically put an end to the emergence of the touch paint brush for bad also to have certain to improve, greatly improved the technological level, reduce the loss of rework.

Customers to use instance